Views: 0 Author: TOPBOLT technical team Publish Time: 2026-11-18 Origin: Site
Dacromet coating is widely used for its good salt spray resistance. Many buyers and field engineers regard it as an all-purpose anti-corrosion option. It is a common misunderstanding that Dacromet coated fasteners can be assembled directly with all types of metal components without corrosion issues. Dacromet relies on zinc-aluminum sacrificial anode protection. The coating has a fixed electrochemical potential. When it is tightly joined with dissimilar metals with large potential difference, and conductive medium such as moisture, dew or salt mist exists, a galvanic cell forms and galvanic corrosion occurs, accelerating coating degradation. It is recommended to adjust according to actual product standards and working conditions to avoid overpromising.
These combinations often lead to after-sales problems in overseas projects:
Dacromet fasteners directly contact 304 / 316 stainless steel brackets and flanges
Dacromet bolts and washers fit directly against aluminum profiles or aluminum castings
Dacromet parts assembled with brass or copper components for long-term outdoor service
Galvanic corrosion differs from general rusting. Damage concentrates on the contact boundary of two metals:
White zinc corrosion products appear at contact areas
Coating is consumed rapidly and loses protection for steel substrate
Red rust forms on base metal and reduces connection strength
Corrosion progresses much faster than Dacromet fasteners exposed separately
Fastener Coating | Mating Material | Galvanic Risk | Description |
|---|---|---|---|
Dacromet (Zn-Al) | 304 / 316 Stainless Steel | High | Stainless steel has nobler potential. Dacromet coating corrodes preferentially under humid conditions |
Dacromet (Zn-Al) | Aluminum Alloy | Medium-High | Potential difference is moderate, corrosion likely in coastal and dew-rich environment |
Dacromet (Zn-Al) | Carbon Steel | Low | Compatible pair for normal applications |
Dacromet (Zn-Al) | Brass / Copper Alloy | High | Copper is noble, coating wears out quickly without insulation |
Insulating gaskets break the conductive path between Dacromet fasteners and dissimilar metals. Nylon, EPDM and fiberglass epoxy gaskets are widely accepted by site inspectors. Gaskets must have suitable temperature and compression resistance to prevent creep and loss of preload.
Use fasteners with coating compatible with the parent material. Stainless steel components match passivated stainless steel fasteners; aluminum structures use aluminum-based coatings. This method applies to assemblies with tight clearance where extra gaskets are not allowed.
Sealant and sealing gaskets block moisture and salt spray from entering contact gaps. Sealing is not a standalone solution, it is normally used together with insulating gaskets for curtain walls and pipe supports.
Besides salt spray hours and coating thickness, confirm the material of connected parts before ordering. Drawings shall clearly specify insulation requirements for dissimilar metal joints and share requirements with manufacturers and installation teams.
If bolts are Dacromet while matched nuts and washers use different materials or coatings, galvanic corrosion may still occur. Cracked or offset insulating gaskets will cause local metal-to-metal contact and protection failure.
Galvanic corrosion develops slowly in permanently dry indoor space, and the requirement can be relaxed. If condensation happens due to temperature change or water leakage, follow the humid environment protection rules.
No visible rust does not mean no corrosion risk. Corrosion will start quickly once moisture penetrates the joint. Disassemble and add insulation if possible. If disassembly is impossible, seal the gap externally and arrange regular inspection.